Filter
Top Products
CHANGING DEFAULT SETTINGS (SERVICE PROGRAM MODE)
Procedure 2
You can change the settings of the following 7 service programs using
this procedure.
SP No. Mode
Default
29
Adjust background image in Photo
O: No
or Line/Photo mode
79
Quality Start setting
O: No
84
Auto Multi Copy mode selection
O: Multi Copy mode
87
Memory Stack mode
O: Memory mode
88
Auto Memory/Class mode
O: Memory/Class mode
89
Tint mode setting
O: No
142 /[PaDer size detection selection
II1: Yes
Up to 3 service programs among the above 7 service programs can be
registered in the CS Mode key. When you recall registered setvice
programs using the CS Mode key, the setting is changed and you can
make prints.
How to register SP modes in the CS /ldoc/e key
c1
u
o
Enter the service program
mode and select the service
program number you want to
register. * See page 114.
While pressing the CS Mode
key, press 2, 3 or 4 using the
Number key until the beeper
sounds.
Make sure that the previous func-
tion registered under the selected
number (2, 3 or 4) is overwritten.
117
....=. .. WWwww
---
r---
‘--J-- I ---- ---- .--=-- .- , --- ~. _r_.-z
if instructions are not followed.
~Caution:lmpoflant information on how to prevent damage to your equip-
ment, or how to avoid a situation that might cause minor injury.
- WARNING -
n Do not modify or replace any parts other than the ones specified in
this manual.
a Since some parts of the machine are supplied with high voltage, touch
only the parts specified in this manual.
a Do
not operate the machine without covers. You might get your fingers
caught in the machine, or the machine might be damaged because, for
example,
dust or the like
might get
inside
it.