Filter
Top Products
OPERATION NOTES
If you cannot pull out the drum, press the drum rotation button until it be-
comes green.
The leading edge of the prints might become stained if the edge touches the
image of prints on the paper delivery table.
The ink of the print on the paper delivery table might stick to the back side of
the next print.
When the machine is on and the power source is less than 90% of the
specified amount, printing quality will decrease. Therefore, make sure the
supply from your electrical outlet is at least 90% of the required amount.
As various kinds and qualities of paper exist, some paper might be wrapped
around the drum or cause misfeeds.
If your hands are stained with ink:
Avoid prolonged or repeated contact with skin.
Cleanse skin thoroughly after contact, before breaks and meals, and at the
end of the work period.
Ink is readily removed from skin by waterless hand cleaners followed by
washing with soap and water.
Also, be careful not to get any ink on your clothing while emptying the mas-
ter eject box or while loading a new ink cartridge.
The image density varies according to the printing speed and the room tem-
perature. So, adjust the printing speed or increase the room temperature.
When you make a lot of prints from a small image, ink may ooze out from
the edges of the master, especially under high temperature and when print-
ing in two or more colors. In this case, make a new master.
Use ink made within one year. Ink stored for a long period tends to dry
slowly and yield
While making a
feeder open.
When you store
pointing up.
lower image density.
master, do not leave the platen cover or optional document
1,000 ml/pack ink, make sure to store it upright with the cap
If you use originals of letters in Light or Dark Tone function, edges of the
letters may be printed clearly and inside of the letters may become screened
image.
In Line/Photo mode, moire patterns may occur when screened originals are
printed. In this case, make prints in Line or Photo mode.
206