Filter
Top Products
3-16
Chapter 3
Installing the System
Installing Board in a Slot
Install a board in the slot of the SMG-3200 system, after procedures for daughter board installation
is completed.
When installing the board, keep the followings in mind.
y
The high voltage static-electric charge is easily accumulated in a human body. Deal with the
board after removing all the accumulated electric charge by touching any equipment’s device or
the grounded part.
y
Don’t touch the Edge connector of the board and the jumper pin, if possible.
y
You have to ground the surface of a workstation, on which the board is place, after wrapping it
with conductor. And you also can put the Ground clip connected to the anti-static carrying bag
to use the station.
y
When you have to touch the board, it is recommended to put an anti-static strap on the wrist, if
possible.
After understanding all these cautions, attach the boards on the slots in the following way
according to the system. This section describes board installation procedures in a system slot in the
case of the MGCB board. Other boards can be installed in the same method.
1. Prepare board to install, ensure there is no defect on the board, and ensure the jumper or switch
configuration is correct.
2. Referring the above directions, select a slot for board installation based on the type of board.