Filter
Top Products
4-3
AC 120-240V
OFF(O)
ON(I)
OFF(O)
ON(I)
Starting SMG-3200
This section describes the login procedure using CLI, after turning on SMG-3200.
Turning on
While the hyper terminal window is on the screen, turn on the SMG-3200 with the power button in
the rear of the system.
After the system turn on, system initialization proceeds approximately 60 seconds. The system
POST (Power On Self Test) will be executed and the factory-preset configuration data will be
loaded and shown on the terminal.
If booting of the SMG-3200 is successfully completed, then
y
On the MGCB board,
☞
L2 LED and PWR LED are on in green.
☞
OPER LED blinks in green.
y
On the VOIP board,
☞
8CH LED is on in green
☞
LD1 LED blinks in green.