Filter
Top Products
Print Speed
Command Structure <ESC>CSa
a = Designates the speed selection
See Note 2 for allowable settings
Example: <ESC>CS6
Placement: Must be placed immediately after <ESC>A and
immediately before <ESC>Z in its own separate data stream
Default: As previously set in the printer configuration
Command Function To specify a unique print speed through software for a particular
label. This allows flexibility in finding the best performance and quality
for the particular label format, media, and ribbon. All subsequent
labels will print at this speed unless the speed is changed with this
command or through the Operator Panel.
Input to Printer
<ESC>A
<ESC>CS5
<ESC>Z
Printer Output There is no printer output for this command. It sets the print speed of
the printer.
Special Notes 1. This becomes the new setting in the printer configuration for all
subsequent print jobs, unless changed. The setting is stored in
non-volatile memory and is not affected by cycling the power.
2. The allowable Print Speed settings are as follows:
CS Command DSW2-8 OFF DSW2-8 ON
1
2
3
4
5
2 ips (50mm/s)
4 ips (100mm/s)
6 ips (150mm/s)
8 ips (150mm/s)
10 ips (250mm/s)
2 ips (50mm/s)
3 ips (75mm/s)
4 ips (100mm/s)
5 ips (125mm/s)
N/A
Default values are shown in bold type.
Section 4. Programming Reference
Page 4-629001041 Rev. DSATOM-8400RV