Filter
Top Products
LABEL DISPENSE OPTION
The M-8400RV Label Dispense Option is an external mechanism that provides
the ability to print labels in the “demand” mode. It is attached to front of the printer.
When the label dispenser is installed and configured for operation, the printer
dispenses one label at a time, peeling the backing from the label, which allows for
immediate application to the product by the operator.
Operator Setup
The following steps should be taken to set up the Label Dispense Option.
1. Install the option using the instructions provided with the unit. The installation
time is approximately 30 minutes.
2. Power the printer ON.
3. The printer must be configured to used the label dispenser option. Switches
DSW3-1 and DSW3-2 on the front panel are used to configure the printer. To
enable the dispenser, both DSW3-1 and DSW3-2 should be in the ON position.
4. Remove enough labels from the backing paper to provide 12 inches of backing free
from labels.
5. Open the Print Head assembly and feed the backing paper through the print area
in the normal manner.
6. At the label exit area, feed the backing paper down and behind the Knurled
Roller, then back down and around the Backing Roller.
7. Feed the backing paper out the slot in the bottom rear of the printer and attach to
the Backing Rewind Spindle.
Label Dispenser Routing
Appendix D: Optional Features
SATOM-8400RV9001041Rev.DPageD-3