Filter
Top Products
ROTATED FIELDS
The CL Series printers can rotate each print field in 90° increments using the Rotate
command. There are two variations of this command.
• <ESC>% - The field rotates, but the base reference point for the field
remains the same.
• <ESC>R - The field and the base reference point rotate.
The following data stream will rotate the print field but will not change the base
reference point of the field:
<ESC>A
<ESC>%1<ESC>V800<ESC>H200<ESC>L0202<ESC>XB1E<ESC>Q1<ESC>Z
The following data stream will rotate both the field and the base reference point for
that field:
<ESC>A
<ESC>R<ESC>V0200<ESC>H0100<ESC>L0202<ESC>P02<ESC>XB1E<ESC>Q1<ESC>Z
COMMAND DEFAULT SETTINGS
There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a “default” value
is assumed. The commands and the corresponding default values are:
COMMAND DEFAULT NOTE
Print Rotation 0° (1)
Vertical Reference Point 0 (1)
Horizontal Reference Point 0 (1)
Character Pitch 2 (1)
Base Reference Point H=0, V=0 (2)
4.0"
SATOSATO
2" Label
*SATO*
*SATO*
*SATO*
*SATO*
Section 4. Programming Reference
Page4-89001041Rev.DSATOM-8400RV