Filter
Top Products
5. If using roll labels (or tags), load the
roll onto the Label Supply
Spindle so that the printing side
of the labels faces upwards as it
unwinds from the roll. The labels
should be wound face-in. Push the
roll all the way to the inside of the
printer and push the Label Roll
Retainer snugly against the
outside of the label roll.
6. If using fanfold labels (or tags) set
them on a flat surface behind the
printer. Pass the labels (printing
side up) through the slot in the
rear of the printer.
7. Make sure the labels are routed
under the Label Guide and
through the Sensor Assembly.
8. Open the Label Hold-Down by
squeezing the green tab and the
release tab together. The Label
Hold Down is spring loaded and
will open automatically when the
latch is disengaged. Feed the
labels under the Label Guide,
under the Label Hold Down,
through the Sensor Assembly
and out the front of the printer.
9. Inspect the label routing and verify
that the path matches that
illustrated in the Label Loading
diagram. Set the Adjustable
Label Guide to keep the labels
against the inside of the printer.
10. Close the Label Hold-Down by
pushing downward on the green
tab until it latches closed.
NOTE: If the Label Dispenser option has been purchased, see Appendix D, for
proper label routing instructions.
Label Roll
Label Roll Retainer
Print
Head
Label
Guide
Section 2. Installation and Configuration
Page 2-69001041 Rev. DSATOM-8400RV