Filter
Top Products
Receive Buffer Selection(DSW2-5). Selects the operating mode of the receive
buffer. See Section 5: Interface Specifications for more information.
Protocol Code Selection (DSW2-7). Selects the command codes used for
protocol control. Refer to Appendix E for more information.
M84XX Emulation Mode (DSW2-8). For emulating M-8400 software. Should be
used only if problems are encountered when using existing M-8400 software.
Mode Selection (DSW3-1 and DSW3-2). Selects the operating mode of the
printer. Batch/Continuous disables the label taken (dispense option) sensor.
Label Sensor Selection (DSW3-3). Enables or disables the Label Pitch Sensor. If
the Sensor is enabled, it will detect the edge of the label and position it
automatically. If it is disabled, the positioning must be under software control using
Line Feed commands for continuous media printing.
Back-Feed Selection (DSW3-4). When Back-Feed is enabled, the printer will
position the label for dispensing/cutting and retract it before printing the next label.
See page 2-34 for information on setting the amount of offset.
DSW2-5 SETTING
Off Single Job
On Multi Job
12345678
ON
OFF
DSW2
DSW2-7 SETTING
Off Standard
On Non-Std
12345678
ON
OFF
DSW2
DSW2-8 SETTING
Off Off
On M-8400
12345678
ON
OFF
DSW2
DSW3-1 DSW3-2 SETTING
Off Off Batch/Continuous
Off On Tear Off
On Off Cutter
On On Dispenser
12345678
ON
OFF
DSW3
DSW3-3 SETTING
Off Sensor Used
On Not Used
12345678
ON
OFF
DSW3
DSW3-4 SETTING
Off Enabled
On Disabled
12345678
ON
OFF
DSW3
Section 2. Installation and Configuration
SATOM-8400RV9001041 Rev. DPage 2-17