Filter
Top Products
Cutter Command
Command Structure <ESC><NUL>aaaa
<ESC>~aaaa
aa = Number of labels to print between each cut (01-9999)
Example: <ESC>~0002
Placement: Following the Print Quantity command <ESC>Q
Default: <ESC><NUL>0001 (if cutter enabled)
Command Function To control the cutting of labels when using a SATO cutter unit with
the printer printer. This command allows the cutting of a multi-part tag
or label at a specified interval within a print job.
Input to Printer:
<ESC>A
<ESC>H0020<ESC>V0020<ESC>WB1TEST LABEL<ESC>Q3
<ESC>~0002
<ESC>Z
Printer Output: This set of commands will print 6 labels (3 x 2) with two labels
between each cut.
Special Notes 1. You must have the optional printer Cutter to use this function.
Contact your SATO representative for more information.
2. To use this command, the printer configuration must have the cutter
option enabled. See Printer Configuration in Section 2 of this
manual.
3. If the cutter option has been enabled in the printer configuration
and the cut value (aaaa = 0000), the cutter is inactive.
The <NUL> represents the ASCII 00 Hex character and can be
interchanged with a tilde character.
4. When using the Cutter command, the total number of labels printed
is the product of the cut value and the print quantity. For example,
if the cut value is 2, and the print quantity is 20, then 20 sets of
two labels will be printed.
Section 4. Programming Reference
SATOM-8400RV9001041 Rev. DPage 4-33