Filter
Top Products
CAUTION:
For your protection, SATO printers have been tested and listed by the
Underwriters Laboratories. These tests include the printer and certain electrical
components which are an integral part of the printer as approved. These important
parts include the Print Head, PC Boards, Power Supply and Motor. It is a violation of
the UL listing to replace any of these parts with parts other than those approved as
part of the UL listing.
PLEASE NOTE THAT IF A PART OTHER THAN THESE GENUINE SATO PARTS
IS INSTALLED IN THE PRINTER, THE UL LISTING IS VOID AND THE
APPROVAL LABEL MUST BE REMOVED FROM THE PRINTER.
We strongly suggest that if someone attempts to install such a part on your SATO
printer or, sell you such a part, that you have a written statement from them
indicating that they are aware that installation of the part in question voids the UL
listing and requires the removal of the indication of this listing from the printer.
Finally, we call your attention to the fact that many legal jurisdictions, cities and/or
counties, in the United States prohibit the installation of products such as SATO
printers without a listing by an agency such as Underwriters Laboratories.
REPLACING THE FUSE
Supplies needed: 250V 3A Fuse
1. Turn the printer power off and remove the power cable.
2. On the back of the printer, locate the Fuse Cap on the right-hand side of the AC
connector.
3. Unscrew the cap and remove the defective fuse.
4. Replace with a new 250V 3A fuse.
5. Screw the cap back onto the printer and replace the power cord.
Section 3: Cleaning and Maintenance
SATOM-8400RV9001041Rev.DPage3-7