Filter
Top Products
11. Adjust the outside Label Edge
Guide until it touches the outside
edge of the label and tighten the
thumb screw. Make sure the labels
are also touching the inside edge
guides.
CAUTION: Using media narrower
than the maximum print width may
cause excess head wear due to the
label edge. See page 2-9 for
precautions.
12. If the ribbon is already loaded,
close the Print Head by rotating
the black Head Latch toward the
front of the printer until it latches
closed.
13. If the ribbon is not loaded, see the
following description for loading
instructions.
14. Close both the Access Doors.
Adjustable Label
Edge Guide
Inside Label
Edge Guides
Sensor
Assembly
Sensor Positioning
Adjustment
Route under
Label Guide
Label Hold
Down
Head Latch
Section 2. Installation and Configuration
SATOM-8400RV9001041 Rev. DPage 2-7