Filter
Top Products
The counters are identified in the display as:
HD: Head Counter
DSP: Dispense Counter
CUT: Cutter Counter
LIFE: Life Counter
1. Use the LINE key to select the counter to be accessed, the Head (HD) counter,
Dispenser (DSP) counter or the CUT (Cutter) counter. Use the FEED key to
display the values stored for that particular counter.
2. Pressing the FEED key again will bring up the counter Clear display. To clear the
counter, press the FEED key until the underline cursor is beneath the YES. If you
do not want to clear the counter, press the LINE key until the underline cursor is
beneath the NO. Pressing the FEED key will clear the selected counter if YES was
chosen and bring you to the Exit Advanced Mode Setup display. Note that the
LIFE counter cannot be cleared.
Exit Mode
This allows you to exit the Advanced Mode or to recycle through the selections again.
1. Use the LINE key to step the underline cursor to either the YES or NO selection.
The default position is NO.
2. Once the correct setting is underlined, pressing the FEED key will advance the
display to the OFF LINE mode if YES was underlined or back to the Zero Slash
display if NO was selected.
USER TEST PRINT
This option allows you to print a test label. It is recommended that you print a test
label after you have changed any of the settings in the Advanced Mode. The test label
allows you to verify that you indeed did make the desired changes. To enter the User
Test Print Mode, power the printer on while pressing the FEED key. The printer will
“beep.” Release the FEED key and the printer will display the following message on
the LCD panel:
1. Use the LINE key to step the underline cursor to either the LARGE or SMALL
selection. If LARGE is underlined, a label will be printed for a maximum width label.
The default position is LARGE.
COUNTERs
hd dsp cut life
HEAD COUNTER
0.0
HEAD CNTR CLEAR
NO YES
Section 2. Installation and Configuration
SATOM-8400RV9001041 Rev. DPage 2-31