Sharp MX-C380 All in One Printer User Manual


 
4-37
FACSIMILE
Contents
3
Press the [BLACK & WHITE START] key.
Scanning begins.
4
If you have another page to scan, change pages and then press the [BLACK &
WHITE START] key.
Repeat until all originals have been scanned.
If no action is taken for one minute, scanning automatically ends and the transmission is reserved.
5
Select the [Read-End] key.
A beep sounds.
Open the automatic document feeder and remove the original.
When scanning is completed, "Job stored." will be displayed together with a job control number.
This number can be used to locate the job in the Transaction Report or in the Image Sending Activity Report.
If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
To change the exposure, resolution, scan size, and send size for each original page scanned, select the [Configure]
key and press the [OK] key. However, when "Card Shot" is selected in the special modes, only the exposure can be
changed, and this can only be done when scanning each even page number of the original pages.
To cancel transmission...
Press the [STOP] key ( ) before selecting the [Read-End] key and pressing the [OK] key.
If a fax is being received when the transmission operation is performed, the transmission will be reserved and transmission
will take place after fax reception is completed.
If the memory becomes full while the originals are being scanned, a message will appear and transmission will be
cancelled.
OKBACK