Filter
Top Products
Safety Notices
This rinteriscertifiedasaClass 1 laserproductundertheU.S.Departmentof HealthandHumanServices
(DHl?S) Radiation Performance Standard according to the Radiation Control for Health and Safety Act
of 1968. This means that the printer does not produce hazardous laser radiation.
Since radiation emitted inside the printer is completely confined within protective housings and external
covers, the laser beam cannot escape from the machine during any phase of user operation.
The Center for Devices and Radiological Health (CDRH) of the U.S.Food and Drug Administration
implemented regulations for laser products on August 2,1976. These regulations apply to laser products
marketed in the United Stales. The label on the printer indicates compliance with the CDRH regulations
and must be attached to laser products marketed in the United States.
Caution-use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
Federal Communications Commission
Radio Frequency Interference Statement
This equi
to Part 1 P
ment has been tested and found to comply with the limits for a Class B digital device, pursuant
of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and. if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
bedeterminedbytumingtheequipmentoffandon,~euserisencouraged to trytocorrecttheinterference
by one or more of the following measures:
* Reorient or reloate the receiving antenna.
* Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
* Consult the dealer or an experienced radioKV technician for help.
For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.
Tk above statemenls apply only to printers markled in lk U.S.A.
Self Declaration
Radio interference regarding this equipment has been eliminated according to Vfg 1056/1984 announced
by the DBP.
DBP has been informed of the introduction of this special equipment and has been granted the right to
examine the whole series.
It is the user’s res nsibility to see that his own assembled system is in accordance with the technical
T
regulations under fg 1046/1984.
To conform to FlZ-regulations it is necessary to make all connections to the printer with shielded cable.
The equipment may only be opened by qualified service representatives.
Tk above s~a~emenl applies only IO prinlers ma&led in West Germany.
-
-
-
-