Filter
Top Products
l Reset -To clear the printer memory and restore settings to emulation
defaults, press [RESET].
Before you begin printing, at any time, but especially when you are new to
the process, it is a good idea to run a test or sample print. To do this, take
the printer off line. Then press and hold [TEST] until the display reads
Status Sheet. The printer will provide a series of 4 sheets showing.
l its configuration
l the quality of its text printing, and
l a summary of its settings - current, initial, power-up and factory
preset.
CONNECTING THE PRINTER TO THE COMPUTER
The Star LaserPrinter 8111 comes equipped with both a standard parallel
interface and an RS-232 serial interface. Both can be connected simulta-
neously, though only one can be active at any one time.
The printer comes from the factory pre-set with the IBM parallel interface
active. You can confirm this by looking at the Interface Group portion of
the sample print.
INTERFACE GROUP:
Intorfaco Typo PARALLEL IBM
PARALLEL IBM
Swill Parrmotms:
Baud Rat@ 9600 baud 9600 baud
Data Bits 8 8
Parity
.Nona Non*
Stop Bits 1
1
Protocol XON/XOFF
XOW/XOFF
This means that the IBM parallel interface is active. If the serial port were
active, that line would state SERIAL.
-
-.
50