Filter
Top Products
Whik Tabs
When the board is completely seated, it will be entirely inside the slot.
Finally, replace the coverplate. Fit the lip behind the printer frame at the left
end of the slot. Then visually line up the hole in the cover with that in the
frame. Hold the right edge of the cover plate away from the printer frame
and reinsert the screw. Slide the cover back into position until the screw
enters the hole in the frame. Tighten the screw with the screwdriver.
If you want to remove the expansion board, unscrew the slot’s cover plate.
Grasp the plastic tabs with two hands and pull evenly on them until the
board comes unplugged. Do not wiggle the board back and forth as you pull,
to avoid damaging the pins.
23