Sun Microsystems CP3220 Server User Manual


 
Chapter 1 Introduction 1-11
10/100/1000BASE-T per second Ethernet RJ-45 port from the host to the rear of the
system. This port can be used to accomplish, optionally, a network boot as a diskless
client. The other configurations require IHV hardware.
TABLE 1-1 I/O Configurations
I/O Hardware Required Description
Ethernet Sun Netra CP32x0 ARTM,
supplied as an option for rear
access
The default boot path uses an Ethernet port; the blade server
runs in a diskless client configuration
SAS Sun Netra 146-GB hard disk
and the Sun Netra CP32x0
ARTM
Available only with the optional Sun Netra CP32x0 SAS Storage
Advanced Rear Transition Module, Dual HD or through an
AMC card with SAS capabilities. When the optional rear
transition module is installed, connect to the drive(s) via SAS
ports on the rear transition module.
Serial data
Serial data
Sun Netra CP3220 blade server
Sun Netra CP32x0 ARTM rear
transition module
Serial port A on the front panel provides the path of the default
console I/O.
When the optional transition module is installed, the module’s
serial port A will become the path of the default console I/O
(
FIGURE 1-5).
Compact
Flash
IDE Compact Flash card Sun Netra CP3220 blade server supports one, optional IDE
Compact Flash drive, either 8-Gbyte (Type I) or 16-Gbyte (Type
II), installed in a Type II CF socket on the blade.