Filter
Top Products
Chapter 2 Hardware Installation and Service 2-29
7. Press on the front face of the AMC card until the card is fully seated into the
AMC connector.
8. Press the black ejector in, toward the AMC card, to activate the card.
9. Refer to the AMC module documentation for software and cabling installation
instructions.
2.3.9 Adding or Replacing a TOD Clock Battery
The optional TOD battery must be type CR1632, with a minimum of 4ma abnormal
charging current rating (for example; a Renata CR1632).
Caution – Risk of explosion if the battery is replaced by an incorrect type. Dispose
of batteries properly in accordance with manufacturer’s instructions and local
regulations.
To install battery, perform the following steps:
1. Remove the old battery, if necessary.
2. Slide the new battery into the holder with the side labeled “+” facing up.
2.3.10 Changing Jumper Settings
2.3.10.1 Clearing the CMOS Setting Using Jumper 1
Reset jumper 1 to clear the CMOS settings, which restores the default BIOS settings.
Jumper 1 is shown in
FIGURE 2-10. The jumper housing should be stored in the P1/P2
position, which is the run position.