Filter
Top Products
Chapter 2 Hardware Installation and Service 2-35
▼ Setting OOS LED Behavior
Note – You must always perform a read, modify, and write to change any of the bits
in the control byte.
● At the clia CLI, enter the Set IPMI Control Bits command.
Data Bytes
Command NetFn Opcode
Set IPMI Control Bits 0x2E
0xE9
Type Byte Data Field
Request Data 1 00
200
32A
4 Control byte:
Bit 0 = LED 2 (Green LED) control bit.
• 1 = IPMC controls green LED.
• 0 = IPMC does not control green LED.
Bit 1 = OOS LED1 (Amber/Red LED) control bit.
• 1 = IPMC controls LED1 for default behavior.
• 0 = IPMC does not control LED1.
Bits 2 to 7= reserved for future use
Response Data 1 Completion Code:
• [00] OK
• [C1] Command not supported
• [CC] Invalid data in request
(Refer to IPMI
specification for more completion
codes)
200
300
42A