Filter
Top Products
Chapter 8 Removing and Replacing Components 89
2. Hold the On/Standby switch in the Standby position for more than four seconds
to put the server in standby mode.
3. Disconnect the power cord.
4. Disconnect all other cables.
5. If the system is installed in a rack or cabinet, remove it.
▼ To Remove the Top Cover
■ If the Sun Fire V100 server is not in use, go straight to step 1.
■ If the server is already in use, see “To Change Components In a Sun Fire V100
Server That Is In Use” on page 88.
FIGURE 8-3 Removing the Top Cover
1. Place the unit on an ESD surface and attach an antistatic wrist strap (see
FIGURE 8-2).
2. Unscrew the captive screw from the back of the unit (see
FIGURE 8-3).