Sun Microsystems Sun Fire V100 Server User Manual


 
24 Sun Fire V100 User’s Guide December 2001
RJ-45 to RJ-45 patch cable
Both are supplied with the Sun Fire V100 server.
To Connect to the Server Using a Sun
Workstation
1. Connect to the server using the RJ-45 patch cable and DB-25 adapter as described
in “To Use the DB-25 Adapter” on page 23.
2. From a terminal session, type:
The tip command above is for a console that is using its ttya serial port. If you later
configure your console to use ttyb, type the following to set up a tip session:
For information about dedicating the console to Serial B, see “Managing the Sun Fire
V100 Server From the lom> Prompt” on page 43.
For information about how to power on and configure the server, go to “Powering
On and Configuring the Server” on page 34.
To Connect to the Server Using an ASCII
Terminal
1. Set up a connection between the terminal and the Sun Fire V100 server.
See “To Use the DB-25 Adapter” on page 23.
2. For the General terminal settings, refer to the terminal operating manual.
# tip /dev/term/a -9600
# tip /dev/term/b -9600