Filter
Top Products
Chapter 4 Powering On and Configuring the Sun Fire V100 Server 35
1. Connect the server to the power supply but do not power it on.
2. Set up a serial connection to the Serial A/LOM port and also a connection to at
least one Ethernet hub (as described in Chapter 3).
3. At the console lom> prompt, type the following command to power on the server:
For more information about the lom> prompt and the commands that are available
from it, see Chapter 5.
During booting you will be prompted for certain information. The information you
provide determines the configuration of the server.
4. Specify the type of terminal you are using to communicate with the Sun Fire V100
server.
5. Specify whether you need IPv6 enabled, and then follow the instructions on the
screen.
6. Specify whether you want to enable the Kerberos Security mechanism, and then
follow the instructions on the screen.
7. When prompted, give a password (if any) for users logging in as root.
The system will boot when you have provided it with the information it needs.
▼ To Power On Without the Server’s Details
Registered at a Name Server
Follow the instructions in this section if you do not have a Name Server configured
on your network.
Tip – Read these instructions through before you follow them, to see what
information the system will prompt you for when you start it for the first time.
1. Connect the server to the power supply but do not power it on.
2. Set up a serial connection to the Serial A/LOM port and also a connection to at
least one Ethernet hub (as described in Chapter 3).
lom> poweron