Sun Microsystems Sun Fire V100 Server User Manual


 
Chapter 3 Communicating With the Server 29
Connecting to the Server Using a
Handheld Device
The Sun Fire V100 server can be configured from a handheld device that uses
PalmOS 2.0 or later, as long as you have VT100 terminal emulation software
installed on the device and the correct hardware with which to connect to the server.
To Set Up the Hardware
Note To connect a handheld device to a Sun Fire V100 server you need a male DB-
9 adapter that performs the same crossovers as those listed in TABLE 3-5.
1. Connect the RJ-45 cable supplied with the server to the server’s A LOM port.
2. Connect the other end of the cable to the DB-9 adapter.
3. Connect the DB-9 adapter to the serial cable leading to your PalmOS device’s
cradle or travel kit.
To Set Up the Software
Note To configure the Sun Fire V100 server from a handheld device, you need
VT100 emulation software installed. The following procedure was based on a
package called “Online” which is available from http://www.markspace.com/
online.html#Getting. This web address also gives you information on
installing and using the software.
Once the program is installed:
1. Go to the Applications menu.
2. Click the Online icon.