Sun Microsystems Sun Fire V100 Server User Manual


 
Chapter 6 Managing the Sun Fire V100 Server From the Solaris Prompt 77
To turn the Fault LED off, type:
To Change the First Character of the Sequence
for Escaping to the lom> Prompt (lom -X)
The character sequence #. (hash, dot) enables you to exit the Solaris prompt to the
lom> prompt.
To change the first character of this default lom escape sequence, type:
where x is the alphanumeric character you want to use instead of #.
Note If you are at the console and you type the first character of the LOM escape
sequence (by default this is #), there is a delay of one second before the character
appears on the screen. This is because the system waits to see if you type the dot (.)
character next. If you do, the lom> prompt appears. If you do not, the # character
appears. If you want to change the LOM escape character, use a character that is not
included in any console commands; otherwise the delay between your striking the
key and the character appearing on the screen may affect your typing at the console.
To Stop LOM From Sending Reports to the Serial
A/LOM Port (lom -E off)
LOM event reports can interfere with information you are attempting to send or
receive on the Serial A/LOM port. By default, the Serial A/LOM port is shared by
the console and LOM. LOM interrupts the console whenever it needs to send an
event report. To prevent LOM from interrupting the console on Serial A/LOM, turn
serial event reporting off.
To stop LOM from sending reports to the Serial A/LOM port, type:
# lom -F off
# lom -X x
# lom -E off