Sun Microsystems Sun Fire V100 Server User Manual


 
Chapter 5 Managing the Sun Fire V100 Server From the lom> Prompt 57
By default, all four areas of authorization are available to each named user you set
up. You can limit users to a particular area or areas of authorization by specifying
permissions for a named user.
To Specify Permissions for a Named User
Type:
You can specify:
All four parameters (for example, userperm cuar)
This also makes all four areas available to the named user.
One, two, or three parameters
This makes only the parameter or parameters you specify available.
The parameters are:
c
This stands for “console permission”. It enables the named user to exit from the
lom> prompt to the Solaris prompt (as long as the Serial A/LOM port is shared
between LOM and the console).
u
This stands for “user administration permission”. It enables the named user to
add and delete users and alter their areas of authorization by using the userperm
command.
a
This stands for “administration permission”. It enables the named user to change
the LOM device’s configuration variables (see “Setting the LOM Configurable
Variables” on page 58).
r
This stands for “reset permission”. It enables the user you have named to reset
the server and to power it on and off using the LOM device.
-
Use this character to specify that no permissions are assigned.
lom> userperm username [c][u][a][r][-]