18
VISION 5000 Videoconferencing SystemInstallation
Configuration
For each installation of the Vision 5000 it is necessary to configure the unit. All configuration parameters are
available via the Terminal Settings menu through the on-screen menu system. If you are using an external
IMUX or special networks, the external equipment may also need to be configured.
Press
MENU
on the remote control. Select the menu Terminal Settings, then Network.
ISDN-BRI configuration
When using the internal SoftMux on ISDN-BRI, select Current Network: ISDN-BRI, enter ISDN-BRI
Settings, select Switch Type and Line1-4 Setup. For details, follow the instructions in chapter Terminal
Settings, ISDN-BRI Settings in this guide.
For further information refer to the examples in:
Appendix 1: Connecting Vision 5000 to ISDN using NT1 network adapters
Appendix 2: Connecting Vision 5000 to the Switched 56 network
ISDN-PRI/T1 configuration
When using the internal SoftMux on ISDN-PRI/T1, select Current Network: ISDN-PRI/T1, enter ISDN-
PRI/T1 Settings and specify needed parameters. For details, follow the instructions in chapter Terminal
Settings,ISDN-PRI/T1 Settings in this guide.
External Network configuration
When using external network equipment such as an external IMUX or terminal adapters for special
networks, select Current Network: External and set your network specific parameters via the External
Network Settings option. For details, follow the instructions in chapter Terminal Settings,External
Network Settings in this guide.
Language and Dual Monitor configuration
To select a different language, select Terminal Settings, Language.
If you are using two monitors, Dual monitor should be selected On in the Video Output menu.
The Vision 5000 is now configured and ready to make a call.
