Filter
Top Products
VISION 5000 Videoconferencing System
91
Appendix 2
Configuring your CSU/DSU
Recommended configuration of your CSU/DSU using TANDBERG equipment.
Motorola UDS SW-56 Software revision : 350427RF
Transstream T1100 With RS-366 Apac
Transstream T1000 With RS-366 Apac
Inc CM-1056,CM-1056 DP
Adtran DSU III S4W
Motorola DSU
DSU Line 56000bps
TIMING DDS
OPERATION OVER SW. LINE YES
DTE 56000 bps.
DTE TIMING SLAVE
SYNCHRONOUS DATA
BUFFER DISABLED
CTS FOLLOWS RTS
ANTISTREAM OFF
DCD NORMAL
DSR ON DURING LOOPBACK
DTE RL DISABLED
DTE LL DISABLED
DTR AUTO DIAL OFF
RESPONDS TO DTR
EIA-366 DIALER
SPEAKER DISABLED
BISYNC DIAL OFF
HDLC OFF
Adtran DSU III S2W/4W
Config
Local
Network options
Network Type = AT&T /MCI/Other
or Sprint
DTE Options
DTE Rate = 56k
Connector Type = V.35
Data Format = Synchronous
DTE CMD Option = Disabled
Transmit Clock = Normal
CS Options = Forced On
CS Delay Short
CD Options = Normal
TR Options = Idle When Off
SR options = Forced ON
Test Options Ignore
Dial Options
Auto Answer = Disabled (In some cases: enabled)
RS 366 EON = Enabled
Manual Command Ignore
Transstream T1100 DSU
Network Accunet.
Auto Answer Yes
DTR Asserted No
DSR Asserted Yes
RTS Asserted Yes
CTS in Data Mode Yes
Audible Alarm Off
Remote Loop Back Ignore
Wait for answer 060
Speaker On
Transstream T1000
DIP switches should be set in the following way, where the bold selections
shows which settings to choose:
SW2 SW3
Left Side Right Side Left Side Right Side
1 Sync Async Normal Auto originate
2 Normal Autobaud Normal Far End Loop
3 Command Port Port A Normal Local Loop
4 Data Port Port A Normal Line Loop
5 7 Bits 8 Bits Int. Clock External Clock
6 Normal DTR Assert Normal Back to back
7 Normal RTS Assert Normal Adapt
8 Normal CTS Delay Auto Answer Manual
INC DSU
Set the DIP switches set as follows.
1. RS-232 Dial Port DOWN/OFF
2. Loop Master DOWN/OFF
3. System Status UP/ON
4. Switched 56 Operation UP/ON
5. Keypad Enable UP/ON
6. Permanent Request To Send DOWN/OFF
7. Permanent Data Term. Ready DOWN/OFF
8. Circuit Assurance DOWN/OFF
9. Data Mode During Local Loop UP/ON
10.Remote Digital Loop Enable UP/ON
For configuration of other CSUs refer to the appropriate user manuals.