TANDBERG 5000 Webcam User Manual


 
VISION 5000 Videoconferencing System
45
Advanced use
Automatic call-up
When the automatic call-up function is On, the connection of the RTS line to the CTS line on Data Port 2 will
initiate an out-going call to the number stored in entry 01 in the Directory (reserved for special applications).
MCU status line
During an MCU conference, a status line is displayed by default which provides user information about the
conference. To remove this status line, select MCU Status Line: Off.
System Name
Identifies the system during an MCU conference call, when using the Web-interface and when the codec is
acting as an SNMP Agent.
Presentation Settings
This menu allows setup of still-image/graphics transfer.
====== Presentation Settings ======
Presentation Mode: Normal Preview
Still image source:
Current Video1 Video2
Video3 Video4 Video5
Previous Menu
Presentation Mode: Normal
To send a still-image immediately after pressing
GRAPHICS
FREEZE
, select Presentation Mode: Normal.
Presentation Mode: Preview
To preview your image before it is transferred as a still-image, select Presentation Mode: Preview. When
pressing
GRAPHICS
FREEZE
you will be allowed to view your image, e.g. from the document camera, before sending it as a
still-image by pressing
GRAPHICS
FREEZE
again.
Still image source
To select a default still image source, e.g. the document camera connected at video input 3, select Still
image source: Video3. When pressing
GRAPHICS
FREEZE
the system will switch to the chosen video input and send a still
image from this video input. After the image is sent the system will switch back to the original video input.
To send a still image from your current video source, select Still image source: Current.