Filter
Top Products
VISION 5000 Videoconferencing System
55
Advanced use
Audio Outputs
============= Outputs =============
Out1: Off On
Out2(AUX): Off On
Out3(VCR): Off On
Level Settings
Previous Menu
Audio out 1 is intended for connection to Tandberg Natural Audio module, televisions or audio amplifiers
with loudspeakers.
Audio out 2 is intended for connection to audio recording equipment or to a telephone add-on hybrid. The
signal is a mix of audio from both the remote and local side (not from Audio in 5).
Audio out 3 is intended for connection to a VCR or other recording equipment. The signal is a mix of audio
from remote side and local side (not from Audio in 6).
NOTE
Never connect audio out 2 or audio out 3 to a loudspeaker placed in the same room as the microphones
connected to the system. Doing this will cause howling and possible damage to the speaker system.
If an output is Off, no audio will be sent to that output.
Level Settings - Outputs
========= Level Settings =========
Out1: |||| +13.5dB
Out2(AUX): |||| +13.5dB
Out3(VCR): |||| +13.5dB
Previous Menu
Adjust the audio output levels according to the parameters of the external audio equipment connected. These
levels should be adjusted when installing new audio equipment only. The default settings are correct for the
Tandberg Natural Audio module and for most consumer electronics devices (televisions, CD-players, VCRs, etc.).
The audio output levels specify the maximum level of the output.The audio outputs are adjustable in steps of
1.5 dB from 0 dB to 22.5 dB.
The volume control on the remote control will control the level of output 1 (the speaker output). The volume
control will have no effect on output 2 and 3.