Filter
Top Products
Health Care System III
17
Introduction
Mobile Camera Cart (optional)
Camera
A standard, continent specific (NTSC for North America or PAL for Europe) TANDBERG WAVE camera is
mounted on a fully adjustable arm on the mobile stand. The camera provides high resolution images with a
fast pan/tilt/zoom action that is controlled from the Tandberg remote control. Up to ten camera positions can
be stored. To move the camera, always hold it by the handle and not its body.
Cart
The mobile camera cart provides excellent stability, the necessary height for the camera, and allows for easy
movement in confined areas. A large handle is provided midway along the main support post. Five castors
are used for stability and two of them can be locked by stepping on the foot lock. The bar above three of the
castors is provided for a foot rest.
A shelf is provided for holding other hospital approved specialized cameras for attaching to medical devices
such as otoscopes, opthalmascopes, etc. To securely hold various sized equipment, the width of shelf is
adjustable by loosening and tightening the two large thumbnuts underneath the shelf. The back of the shelf is
also used for holding the mobile camera remote control.
The hospital approved equipment that is used with the mobile cart must be plugged into either the power bar
within the main HCS III cart, or into the same receptacle that the power cord of the main HCS III cart is
plugged into.
A microphone/video connection box located at the back of the shelf, provides one video input connection and
one microphone connection. A short video cable is provided to attach a medical device on the shelf to the
video input connector. The microphone input is typically used for a microphone that is clamped to the cart
handle, such as that provided in the optional microphone package (described in next section).
The box at the bottom of the cart holds the connectors for the main unit-to-unit cable, as well as the mobile
camera control device.
Height Adjustable Camera Arm
The height adjustable camera arm clamp incorporates two
release handles and provides the camera with approximately
39 inches of vertical movement. This enables a physician to
have precise placement of the camera all the way down to the
height of an examination table.
Relative to the floor, the height of the camera lens can be
adjusted from approximately 45 inches (with camera lens
fully tilted up) to 83 inches.
Arm Clamp
Limit Collar
Arm Clamp
Limit Collar
Cable Holder
Release
Handles
Height
Adjustable
Arm Clamp