Filter
Top Products
72
Health Care System IIIAdvanced Use
Network Configuration
Before using the system it is necessary to specify which network to use and define its settings.
If you want to use your system via ISDN-BRI you should select ‘Current Network: ISDN-BRI’ and enter
the ‘ISDN-BRI Settings’ menu to set the BRI parameters.
If you want to use your system via ISDN-PRI you should select ‘Current Network: ISDN-PRI’ and enter
the ‘ISDN-PRI Settings’ menu to set the PRI parameters.
If you want to use special networks and connect using RS449, V.35, X.21 or connect to ISDN via an external
IMUX you should select ‘Current Network: External’ and enter the ‘External Network Settings’ menu to
set the External Network parameters.
If you want to use your system via ISDN-PRI, you should select ‘Current Network: ISDN-PRI’ and enter
the ‘ISDN-PRI Settings’ menu to set the PRI parameters.
If you want to use your system via Leased E1/T1, you should select ‘Current Network: Leased E1/T1’ and
enter the ‘Leased E1/T1 Settings’ menu to set the Leased E1/T1 parameters.
BOTH ‘LEASED E1/T1’ AND ‘ISDN-PRI’ USES THE SAME PHYSICAL INTERFACE ON THE CODEC MARKED ‘E1/T1’.
If you want to use special networks and connect using RS449, V.35, X.21 or connect to ISDN via an external
IMUX you should select ‘Current Network: External’ and enter the ‘External Network Settings’ menu to
set the External Network parameters.
Terminal Settings
This menu provides basic network setup for the unit and should be used when
installing the system.
NOTE