Filter
Top Products
22
Health Care System IIIInstallation
IF EQUIPED WITH THE ZENITH LCD DISPLAY, THE DUAL OUT S-VIDEO CONNECTOR WILL NOT BE AVA I L A BL E
VCR
• 1 video input supporting composite signals through a BNC connector (Video In 4 on Codec).
• 1 video output supporting composite signals through a BNC connector (Video Out 3 on Codec).
• 1 audio input (line level) via an RCA connector (Audio In 6 on Codec).
• 1 audio output (line level) via an RCA connector (Audio Out 3 on Codec).
USE CABLE TIES TO NEATLY SECURE AND STOW CABLES WHEN REQUIRED.
Warning
Any equipment that is connected to VCR 1 must be powered from either the cart’s internal
isolated power bar or an external isolated transformer, as per the requirements indicated on
pages 4 and 5 under Warning.
To connect a video cassette recorder (VCR)
A VCR is used for sending and recording video sequences. When recording, a VCR will record the incoming
video, the local audio and the audio from the remote side.
Place a VCR onto the shelf above the utility drawer. Connect the VCR’s power cord to the cart’s isolated
power bar located at the back of the PC shelf, as follows:
1) Remove the back panel from the cart’s PC shelf by removing the two screws on the panel’s bottom
corners, and then removing the two screws on the panel top.
2) Remove the cable entry cover from the post.
USE CABLE TIES TO NEATLY SECURE AND STOW CABLES WHEN REQUIRED.
Rear Interface Panel
NOTE
NOTE
NOTE