Filter
Top Products
Health Care System III
27
Installation
Oval cap
Cart Adjustments
Triple-pivot Arm Counterbalance Adjustment
The following procedure applies to the optional LCD display mounting arm and the optional mobile camera
cart arm.
A nitrogen gas spring is used to counterbalance the weight of the LCD
display (or camera). To adjust the weight capacity of the arm, proceed as
follows:
1) Remove the oval cap by prying it off with your thumbnail.
2) Position the arm at 90 degrees with respect to the cart post.
For adjustment purposes, a 3/16” hex wrench is stored in a clip behind the
monitor’s tilt/swivel mechanism.
3) Take the 3/16” hex wrench and insert it into the hole. Turn the screw
clockwise to decrease or counterclockwise to increase the weight
capacity.
4) Remove the hex wrench and check the arm movement. Repeat the procedure if further adjustment is
necessary.
5) When adjustment is complete, re-install the oval cap on the arm and return the wrench to its storage clip
behind the monitor’s tilt/swivel mechanism.
Monitor Suspension Arm Adjustment
To adjust the suspension arm’s counterbalance, proceed as follows:
1) Lift the monitor to its uppermost position.
The counterbalance adjustment screw is accessed from the under side of the suspension arm near the monitor
mounting bracket.
For adjustment purposes, a 3/16” hex wrench is stored in a clip behind the monitor’s tilt/swivel mechanism.
2) Take the 3/16” hex wrench and insert it into the access hole. Turn
the screw clockwise to increase or counterclockwise to decrease the
counterbalance.
3) Remove the wrench and check the arm movement. Repeat the
procedure if further adjustment is necessary.
4) When finished, return the wrench to its storage clip behind the
monitor’s tilt/swivel mechanism.