Filter
Top Products
82
Health Care System IIIAdvanced Use
H.323 Settings
E.164 alias
This is the E.164 address of the codec. The E.164 address is equivalent to a telephone number, sometimes
combined with access codes. Valid characters are 0-9,* and #.
When using a gatekeeper the codec will send a message to the gatekeeper containing both the E.164 address
and the system name of the codec. The codec will not register with the gatekeeper if the E164 alias is not set.
Use Gatekeeper
Auto - The codec will automatically try to register on any available gatekeeper. If a gatekeeper responds to
the request sent from the codec within 30 seconds this specific gatekeeper will be used. If no gatekeeper
responds, the codec will not use a gatekeeper for making H.323 calls and hence an IP-address must be
specified manually.
Manual - The codec will use a specific gatekeeper identified by ‘Gatekeeper IP-address’.
Off - The codec will not use a gatekeeper and an IP-address must be used in order to make an H.323 call.
Gatekeeper IP-address
This is the gatekeeper IP-address if you specify ‘Use Gatekeeper: Manual’.
Announcements
On The codec will announce to the network that it is streaming. This enables a streaming client (e.g. a
PC) to connect to the codec’s streaming session. Used by Cisco IP/TV.
Off No announcement packets will be transmitted.
Video Rate
Defines the Video streaming rate from the system. Range is 16kbps - 320kbps. In addition, audio (G.711)
streaming rate is 64kbps, providing a maximum streaming rate of 384kbps.
Password
Entering a password will prevent unauthorized access to the streaming functionality.
Start/Stop Streaming
By pressing the Quick Key labeled ‘ Start Streaming ‘, the Streaming session will start. To stop the stream,
press the same quick-key, which will be labeled ‘ Stop Streaming ‘ while the streaming-session is active.
Pressing Disconnect will also stop the streaming session.
How to view streaming
After streaming is started, an easy way to view the streamed audio/video is to start your Web-browser and
enter the IP-address of the streaming system. After the Web page of the codec is shown, click on ‘Streaming’.
Alternatively, enter http://<codec ip-address>/stream.sdp.