Filter
Top Products
98
Health Care System IIIAppendix 5
Appendix 5
Using the file system
It is possible to access a file system within the TANDBERG system by using ftp:
DOS-window: ftp <IP-address of codec>, or
Web-browser: ftp:// <IP-address of codec>
Description of the different files
all.prm - all settings in the system (including directory)
dir.prm - directory entries
event.log - logs fault sitations etc.
sw.pkg - the system software
Description of the different folders
user - a folder to be used for custom logos etc.
remote - a folder used for software upgrade of the far end TANDBERG system
What can be done by using the file system?
· software upgrade of the far end TANDBERG system (B3 or above) via ISDN
· upload of custom logos
Software upgrade
· Connect to the system you want to upgrade using ISDN.
· Copy the software file to a folder on your harddisk.
· Open a DOS-window and go to this folder.
· Type ftp <IP-address of your local codec).
· Enter password: <Release Key of far end system>
· Go to the remote folder, type “cd remote”
· Upload the software file, type put <s0xxxxxx.pkg>
· Wait until the following is shown:
226 Closing data connection.
5437569 bytes sent in 808.01 seconds (6.73 Kbytes/sec)
ftp>
· Restart the far end codec.
The far end system should now be upgraded. For further information, please contact your TANDBERG representative.
Custom logos
· Go to the folder where your logo is located.
NOTE: Logo max size: 320x200, or max. 64000 pixels and must be in jpg-format. If the file is too large, no logo will be displayed.
· Type ftp <IP-address of your local codec).
· Go to the user folder, type “cd user”
· Upload the logo, type put <startup.jpg>
The new logo will be displayed the next time you restart your system.