Filter
Top Products
Health Care System III
71
Advanced Use
Address
The IP-address of the PC with the VNC software installed. To find the IP-address of the PC, select
‘Command Prompt’ from the Startup-menu. Type ‘ipconfig’ and press ENTER.
Display Number
The display number for VNC is 0 and upwards. If you are using WinVNC, double-click on the icon on the
toolbar to view ‘WinVNC properties’. This number should correspond with ‘Display Number’ in this menu.
Password
Enter the same password as specified in WinVNC properties. The password will be shown as asterisk signs
(*) the next time you enter the menu.
Start using VNC
To activate VNC, press ‘P
C’ on the remote control. Please make sure that ‘PC’ is set to ‘VNC’ in the ‘Video
Settings Menu’. See also ‘PC SoftPresenter’ section for further information.
VNC Settings
VNC SERVER SOFTWARE SETUP
• BOTH THE PC AND THE VIDEOCONFERENCING SYSTEM MUST BE CONNECTED TO THE LAN.
• A VNC SERVER MUST BE INSTALLED ON THE PC. FREE SOFTWARE CAN BE DOWNLOADED FROM HTTP://WWW.UK.RESEARCH.AT T .COM/VNC
• INSTALL THE SOFTWARE BY RUNNING THE DOWNLOADED FILE.
• TO CONFIGURE THE VNC SERVER SOFTWARE :
• SELECT “ACCEPT SOCKET CONNECTIONS”.
• SELECT “AUTO” FOR “DISPLAY NUMBER”. ‘DISPLAY NUMBER’ IN THE SYSTEM MUST THEN HAVE THE VAL U E 0.
• ENTER A PASSWORD IN THE “PASSWORD”-FIELD. MUST CORRESPOND WITH THE ‘VNC SETTINGS’ ON YOUR SYSTEM.
NOTE