4.13 HDD/SSD 4 Replacement Procedures
Removing the moving HDD/SSD
To remove the HDD/SSD, follow the steps below and refer to Figure 4-18.
1. Disconnect the HDD/SSD FPC from the connector CN1900 on the system board.
2. Remove the HDD/SSD from the slot.
3. Disconnect the HDD/SSD FPC from the HDD/SSD connector.
HDD/SSD
HDD/SSD FPC
CN1900
Figure 4-18 Removing the HDD/SSD
Installing the HDD/SSD
To install the HDD/SSD, follow the steps below and refer to Figure 4-18.
1. Connect the HDD/SSD FPC to HDD/SSD connector.
2. Set the HDD/SSD in the slot in place.
3. Connect the HDD/SSD FPC to the connector CN1900 on the system board.
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-33