Filter
Top Products
2.4 System Board Troubleshooting 2 Troubleshooting Procedures
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 2-25
Table 2-6 Debug port error status (3/8)
Debug
Code
BIOS processing
Target Device IC No.
F131 end of a display setting
F132 Password processing
EC/KBC(EC)
VGA
ICH(USB controller)
RAM
IC3200(EC/KBC)
IC16
00 (ICH)
CN1400,CN1410(RAM
Conn)
F133 setup of ICH (DMAC) ICH(DMAC) IC1600 (ICH)
setup of ICH (PCI)
CPU setup
setup of ICH (MEM IO)
Display setup
setup of PIT
F134
setup of ICH (PIC)
ICH(CMOS,MEM I/O, PIT
Control
ler, PIC Controller)、
EC/KBC(EC,KBC)、
RAM、
BIOSROM、
CPU
IC1600 (ICH)
IC32
00(EC/KBC)
CN1400,CN1410(RAM
Conn)
IC3000(BIOS ROM)
IC1050(CPU)
F135 setup of ICH ICH IC1600 (ICH)
F136 end of Resume processing -
F137 Setup of RAM RAM
CN1400,CN1410(RAM
Conn)
F138 Setup of RAM RAM
CN1400,CN1410(RAM
Conn)
NOTE: Status outputted by the test means the last error detected in the debug port test.
Check 1 If the D port is status F11Eh or F120h is displayed, go to “HDD Trouble shooting
Procedure in Section 2.6.
Check 2 If any other D port status error code is displayed, perform Procedure 3.
D port error code is as follows:
Error code Contents
F003h or F004h SC initialization error
F00Bh BIOS update error
F117h Exception check error
F121h Clock generator error