Filter
Top Products
4 Replacement Procedures 4.16 DC-IN HARNESS/RJ45 WIRE HARNESS
4.16 DC-IN HARNESS/RJ45 WIRE HARNESS
Removing the DC-IN HARNESS/RJ45 WIRE HARNESS
To remove the DC-IN HARNESS/RJ45 WIRE HARNESS, follow the steps below and refer to
Figure 4-21 to 4-23.
1. Disconnect the DC-IN HARNESS from the connector CN8800 on the system board.
2. Remove the DC-IN HARNESS from the slot.
IDC-IN HARNESS
CN8800
Figure 4-21 Removing the DC-IN HARNESS/RJ45 WIRE HARNESS (1)
4-38 [CONFIDENTIAL] TECRA R10 Maintenance Manual (960-708)