Filter
Top Products
13
(to the next page)
Card discharge
slot
Claw
Card stacker
(accessory)
Card stacker
receptacle
Installing the card stacker
1.
Mount the card stacker on the printer.
Hang the stacker claw on the stacker receptacle.
The card stacker is capable of containing
approximately 100 0.76mm-thick cards or 280 0.25mm-
thick cards at the maximum.
Be sure to hang the card stacker
claw on the card stacker receptacle, not the card
discharge slot. If you mount the card stacker at a
wrong place, cards are not discharged, resulting in a
card jam.
CAUTION
Discharging the card
When correctly printed, the cards are discharged from
the left side.
If a card jam or a write error on magnetic stripes
occurs on the way, results differ depending on the
areas.
Portion A: If a card jam or a write error on magnetic
stripes occurs on the way, press the RESET
button, then the ENTER button. The printer
is initialized, and the cards are discharged
from the right side of the printer.
Portion B: See the description in Jam (Transfer) on
p.45.
Portion C: When correctly printed, the cards are
discharged from the left side of the printer.
The cards jamming around this area are
also discharged from the left side.
CB A
Retransfer film cassette
Ink ribbon cassette
Thermal head
Magnetic head
Card turnover table
Feed roller
NG card
discharge slot
Cleaning roller
Card feed roller
Retransfer roller (heat roller)
Bent remedial roller (heat roller)