Filter
Top Products
33
(to the next page)
Setting the bend remedy mode
Single-sided printing may cause a bend depending on
the cards. Adjust the setting to get rid of the bend.
CAUTION
>Bend Remedy>
>>Temp Level
>>Speed
>>Cooling Time
off
-2
-2
ENTER
ENTER
MENU
MENU
MENU
EXIT
EXIT
EXIT
ENTER
EXIT
RESET
ENTER
ENTER
Set the bend remedy roller temperature
There are 9 bend remedy roller temperature settings:
(off and from –5 to +2 the larger the value the higher the temperature).
Bend remedy speed settings
5 gradations can be set
(from –2 to +2, the larger the value the faster the speed.)
Exit user
mode
*After exiting the user mode, press and then press
to initialize.
If initialization is not carried out, the temperature setting will have no
effect on the printer.
Cooling time setting:
16 gradations can be set (none and 1-15, unit: seconds).
Press to select the setting and press to save.
Press to select the setting value and press to save.
Press to select the setting value and press to save.
If the bend remedy temperature
setting is set to off from any other setting, the
preheating status will remain the same until the roller
temperature falls (for approximately 10 minutes).
This is not a malfunction. Leave the unit in ready
status and wait.
Memo
1. Setting temperature and speed of the bend
remedial roller
Adjust the “roller temperature” setting in principle
to correct the bend of the card, and use the
“correction speed” setting for fine adjustments.
2. Setting waiting time for cooling the card
This provides the time for a special film, which
will be marketed in the future, to cool down to
prevent the card and retransfer film from sticking
together after printing.
(The electronic beep sounds.)
(The electronic beep sounds.)
(The electronic beep sounds.)
CAUTION
When printing on both sides is
done with “Remedy roller temperature setting” set to
a high temperature, the cards may show a large
deformation.
Please set this item to OFF for printing on both sides.