Filter
Top Products
20
Set-up (continued)
Loading cards
Load cards when the printer’s LCD shows the message
“Ready” or “No Card,” etc. and not when printer
operations have stopped due to an error. Cards can
also be loaded when the power supply is not switched
on. If there is a drop in the volume of remaining cards
(under 20 cards with a thickness of 0.76mm), the
electronic beep sounds before every feeding.
During printing, if there is a drop in the volume of
remaining cards (under 20 cards with a thickness
of 76mm) an electronic beep sounds.
When “Loading” is displayed on the LCD, do not
open the card tray under any circumstances.
The unit is currently feeding cards. If a message
other than the one above is displayed, cards can
be loaded even while the unit is printing. However,
you are recommended to load cards when the unit
is not printing.
To prevent defective printing caused by
suspended printing or vibration as a result of
opening and closing the card tray, load cards
with care.
Ready
No Card
OR
Loading
When using magnetic cards
When using cards with magnetic strips, set the cards in
the following manner.
For JIS II cards:
Place the card with its magnetic stripes upward and
facing the card bracket.
For ISO cards:
Place the card with its magnetic stripes downward and
facing the card bracket.
Printing on cards with magnetic
strips is not guaranteed.
When using contact IC cards
When using contact IC cards, set in the following
manner.
CAUTION
Place the IC card with its IC
terminal inward and facing the
card bracket.