Filter
Top Products
16
Set-up (continued)
Setting the retransfer film
Do not touch the retransfer film
surface with your hands.
1.
Activate the slide knob and open the printer
door.
When the slide knob is moved, the door opens
downwards. Hold the door with your hand and open it
slowly.
Do not put the ink ribbon or
retransfer film on the back of the door for mounting.
Do not rest your elbows or put any heavy object on
the back of the door as it may break.
2.
Remove the retransfer film cassette.
When you press the lever, a small portion of the
cassette pops out.
CAUTION
Press the cassette
removal lever.
3.
Insert the retransfer film into the cassette.
Stretch the retransfer film along three shafts with the
retransfer face of the film facing outside and insert the
bobbins into the bobbin holders firmly.
At this time, perform setting so that the film is
inside the guide. Make sure to wind the film on to
the wind spool for more than two frames.
Place the cassette upright on a flat surface during set-up.
When you need to take out the
cassette, for instance, to clean the printer, be sure to
put it upright as shown in the above illustration.
When the film is put on the table with its retransfer
face down, dusts attach to the surface, causing a
failure of the printer.
Retransfer film cassette (green)
CAUTION
CAUTION
Shaft
Bobbin holder (green)
Retransfer face
(do not touch
the surface)
Feed spool
(green bobbin)
Wind spool
(black bobbin)
Bobbin holder (black)
Wind the film by
about two frames on
the winding bobbin.
One frame
Guide