Filter
Top Products
18
Set-up (continued)
Setting cards
Please use cards specified by your dealer. This unit
can take both 0.76 mm-thick and 0.25 mm-thick
cards. The factory setting is for 0.76 mm-thickness.
See p.21 to set the thickness switching plate to 0.25
when using 0.25 mm cards.
Fingerprints, soiling, etc. on card
surface can result in print errors. Wear lint-free
gloves when handling.
1.
Open the card tray.
Hold the lower part of the card tray and pull the tray
toward you slowly until it no longer moves.
CAUTION
Caution when loading the retransfer film
cassette and/or the ink ribbon cassette
This describes the caution when the retransfer film
casstte and/or the ink ribbon.
Casstte is removed because of card jam or other
trouble.
Please pay enough attention so that the retransfer film
and/or ink ribbon is maintained at the right position.
Particulary, the ink ribbon is extremely thin, therefore it
apt to slip down when the cassette is removed as
shown in the illustration.
When loaded in this condition, it may cause improper
printing such as INK RUNOUT error, improper color
printing etc.
To avoid this, please handle the ink ribbon and/or the
retransfer film very carefully with hands so that the
media position of take-up side become parallel.
Please do not touch the print side of the ink ribbon and/
or the retransfer film with your hands. Otherwise, it may
cause improper printing.
When adjusting the print position of the retransfer film
and/or ink ribbon, please follow the instruction label
attached on the cassettes.
Improper Winding
Adjust the position with hands so
that the media position of take-up
side and supply side becomes parallel