Filter
Top Products
38
Cleaning the card feed rollers
Dirty rollers are the major cause of jamming of the
cards. It is recommended to clean the rollers once
after printing about 1,000 cards. It is also
recommended to carry out cleaning before the
work, because the retransfer roller (heat roller) does
not operate while it is hot.
1.
Remove the retransfer film cassette.
See p.16 in this manual.
2.
Turn on the power of the printer.
The printer initializes, and the [No Cassette] error is
indicated.
3.
From user mode select cleaning mode.
4.
Press the ENTER button. Select [Rollers] with
↑ and ↓ buttons, and press the ENTER button.
See p.26 in this manual.
Insert the cleaning card in about 10 seconds. If you
fails to set the card within this time, the printer returns to
“Start OK?” Press the ENTER button again to proceed.
>Cleaning>
>User Mode
MENU
>>Rollers
OK?
Cleaning..
Start OK?
ENTER
Cleaning..
ENTER
5.
Set a cleaning card.
Peel off the protective paper from both sides of the
cleaning card and insert it into the card discharge slot.
The card will be drawn into the unit by the rollers and
cleaning will then be carried out. Insert the card with its
adhesive face upside down to repeat the cleaning
procedure once more.
• If the retransfer roller (heat roller)
gets too hot,
appears on the LCD panel, and the printer returns to
the Ready state.
Turn off the power of the printer, and wait until the
roller completely cools down before starting the work.
Confirm that the retransfer film cassette has been
removed.
• The cleaning card does not go into the card
discharge slot at the left side.
• If a card jam occurs, turn off the power, then turn on
the power again. The jammed card will be
discarded.
CAUTION
HR is too hot!
Cleaning card (accessory)
The cleaning card
can be inserted
only from the right
side.
NG card discharge slot
6.
Turn off the power after the cleaning card is
discharged.
Wait for 10 seconds before turning on the power again.
The cleaning card can be used
only once. If you use the dirty cleaning card many
times, the dirt on the card moves onto the rollers,
causing damages to the rollers.
Consult your dealer for the cleaning card.
CAUTION