Filter
Top Products
39
Cleaning the card feed rollers and
heat rollers
Dirty magnetic head will cause a write/read error. It
is recommended to clean the magnetic head after
printing about 1,000 cards. Cleaning the magnetic
head is not necessary if the magnetic stripe card is
not used.
1.
Keep the ink ribbon and retransfer film
cassettes in their mounting positions.
See p.14 to p.18 of this manual.
2.
Turn on the power of the printer.
Go to the next step when the printer is in the Preheat or
Ready state.
3.
Specify the “cleaning” mode in the user mode.
See p.26 in this manual.
4.
Apply alcohol on the magnetic head cleaning
card.
Drip three or four drops of alcohol on the magnetic
stripes.
>Cleaning>
>User Mode
MENU
Magnetic head cleaning
card (sold separately)
Alcohol (sold
separately)
5.
Set the card on the card tray.
Place the card in right direction. See p.20.
6.
Press the ENTER button, select “MG Head”
with the ↑ or ↓ button, and press the ENTER
button.
7.
When the cleaning card is discharged, turn off
the power of the printer.
Wait for 10 seconds before turning on the power again.
>>MG Head
OK?
Cleaning..
ENTER
Replace the magnetic head
cleaning card when it gets dirty. A dirty card may
pollute the head and cause damages to the head.
Consult your dealer on the alcohol and cleaning card.
CAUTION
Once printer servicing and cleaning
have been completed
Once servicing and cleaning of the printer have been
completed, check to make sure that all parts have
been replaced properly.
Improper replacement of parts may result in the power
not turning on or in operating errors.