Filter
Top Products
32
Operation (continued)
Buzzer mode setting
The buzzer indicating errors can be turned on or
off.
Power saving mode settings
The printer enters into the power save mode after a
specified period of time if none of operation buttons
are touched in the Ready state. The heat roller for
retransfer, bend remedial roller, and LCD back-
panel are turned off in the power save mode.
>Buzzer
On
EXIT
ENTER
Exit user mode
Set the buzzer:
there are two settings
(On, off)
Press to select the setting and press to save.
(The electronic beep sounds.)
>Power Saving
off
EXIT
ENTER
Exit user mode
Power saving
settings:
there are 9 options.
(The electronic beep sounds.)
Off:
Not in power saving mode.
Setting options: [5,10,20,25,30,45,60] (units:
minutes)
[5,10,15,20,25,30,45,60] (units: minutes)
If printing is not to be carried out for a period
longer that the set time, switch the unitís heater off.
(Power save status)
When Off is specified,
ⅷ electronic beep sound indicating an error,
ⅷ electronic beep sound indicating the number of cards,
and
ⅷ electronic beep sound indicating settings saved with
the ENTER button in the user mode
are muted.
Press
to select the
setting and press
to save.
Press the EXIT button to cancel the user mode,
and the printer starts.
“Sleeping” appears on the LCD panel in the power
save mode. The operation buttons are disabled in this
mode. See step 2 in “Canceling the power save mode”
to enable the operation buttons.
The printer moves to the power save mode when the
specified time arrives even if you turns off the printer
and turn it on again.
Canceling the power save mode
1.
From the host computer
Enter a control command to print the card. The power
save mode is cancelled, and printing automatically
starts upon completion of preheating.
2.
Temporary cancellation
To cancel the power save mode temporarily on the
printer, press
RESET
, then
ENTER
to initialize the printer.
3.
Permanent cancellation
Cancel the power save mode temporarily as described
in step 2, and change the power save mode setting to
OFF.
Sleeping