Filter
Top Products
25
Be sure NOT to do any of the following during printing
operations:
ⅷDo not open the printer door.
ⅷDo not open the card tray.
(while the LCD panel displays ‘Loading’)
ⅷDo not turn off the power supply.
ⅷDo not unplug the unit.
ⅷDo not pull out the connection cable.
Failure to observe the above points will cause printing
to be aborted and may result in a malfunction of the
unit.
When the printer was occured an
error during printing operation caused by above-
mentioned operation or others, the retransfer film
was rewinded about 3 panels. If the printer is turned
off and on the power or is initialized, the printer occur
the printing an error which is “INK RUNOUT” or print
results problem because of the printer try to print the
used retransfer film. Wind up the retransfer film about
3 panels by unused panel. See p.18 “Caution when
loading the retransfer film cassette and/or the ink
ribbon cassette” and p.25 “On initialization when the
retransfer film casstte and/or the ink ribbon cassette
is loaded”.
Turning off the power
1.
Check the printer status.
In ready, preheat or error status, check that printer
operations are suspended.
2.
Turn off the printer’s power.
Always wait 10 seconds or more before turning the
power back on again.
About the RESET button
When an error occurs in the printer, press the
RESET
button, then the
ENTER
button.
The printer is initialized with this operation.
If the error still persists, see p.41 and take the
appropriate actions.
Then, press the
RESET
button, and the
ENTER
button
again. The printer is initialized, and returns to the
“Ready” state.
(When you turn off the power, these procedures are not
necessary.)
On Initialization when the retransfer
film cassette and/or the ink ribbon
cassette is loaded
Dust or foreign particles may attach on the surface of
retranfer film and ink ribbon when their cassette are
removed from the printer.
This may cause defective printing such as image void,
defective retransfer etc.
To Avoid this, it is recommended that the retransfer film
and the ink ribbon are wound up one or two panels
after they are reloaded.
Please follow the initialization procedure described
below:
1.
Turn the power switch on, and wait until the
LCD indicate or displays “Preheat” or “Ready”.
2.
Depress the
RESET
key.
LCD indicator displays:
3.
By depressing the key or the key,
the LCD indicator change accordingly as
shown below.
Select the wind-up condition, one or two panels.
(This set up is not memorized.)
ⅷ Initialized after two panels of the retransfer film
and the ink ribbon are would up.
ⅷ Initialized after one panels of the retransfer film
and the ink ribbon are would up.
ⅷ Initialized without winding up. (Default)
4.
By depressing the
ENTER
key, the printer is
initialized according to the selected above set
up condition.
Initialize
OK?
Initialize
2'nd Panel, OK?
Initialize
NEXT Panel, OK?
Initialize
OK?
CAUTION