Filter
Top Products
43
(to the next page)
EXT. SW Setting
EXT. Jam
EXT. Comminucate
Error code Description of error Remedy
External device switch setting error Turn the power off and then on again. Call for service if the
problem persists.
External retransfer unit jam error
Press the “reset → enter buttons” and remove cards if they are
not discharged. Press the “reset → enter buttons” and call for
service if the problem persists.
External unit communications error
Turn the power off and then on again. Call for service if the
problem persists.
Mending broken ink ribbon and
retransfer film
If the ink ribbon or retransfer film is broken, mend it
in the following procedures:
1.
Trim neatly the end of broken portions with a
pair of scissors.
2.
Align both ends and apply the Scotch tape in
the center of the aligned ends.
Please do not discard the used ink or film on the
winding side.
3.
Turn the ribbon or film to the winding side with
your hand until the mended portion is
completely wound up.
About printing errors
If blurring or color shifts occur in your print results,
clean all rollers starting with the cleaning rollers.
Some image errors may depend on the design of the
card to print.
In particular, wrinkles can easily occur if large surfaces
are printed with high density ink.
To avoid such problems, contact the dealer where the
printer was purchased concerning card designs.
Align both
ends evenly
Scotch tape
Winding
side
Set the ink ribbon and retransfer
film with care. See p.14 and p.16.
CAUTION